User GuideRevision 1.1 — November, 2014Information and specifications in this document are subject to change without notice.www.cineolighting.com
10For example, a studio lighting installation is best configured with the 150 watt power supply and DMX adapter attached to opposite sides of the yoke.
11SpecificationsLampheadInput voltage: 10.5-28 VDCPower consumption: 75 watts / 120 watts / 135 watts (user configurable)4-pin XLR power inputEtherCon D
12150w AC AdapterPart # 900.0195Input Voltage: 100-240VACOutput Voltage: 24VDCMax. output current: 6.25AOutput connector: XLR4Dimensions: 6.5” x 3.25”
13Warnings, Disclaimers and WarrantyBurning InjuriesBe aware of high temperatures in excess of 50ºC inside the lamphead during and after fixture use. T
14CINEO LIGHTING LIMITED WARRANTYProducts from Cineo Lighting are warranted against defects in materials and workmanship for two years from the date t
www.cineolighting.comSpecifications are subject to change without notice. Cineo Lighting, Cineo Maverick and Maverick are registered trademarks of Cine
2Cineo Lighting has developed the versatile Cineo Maverick Remote Phosphor light source. Maverick operates from many power options, including AC, DC a
3General Notes1. Please read through this manual carefully before operating Cineo Maverick, and keep this manual for future reference.2. There are n
4System Components, Connections and ControlsMaverick LampheadThe Maverick lamphead represents the next generation of Remote Phosphor professional ligh
5Maverick Power SourcesThe Maverick fixture features SmartPower™ power control, allowing operation with any 12-24VDC power source capable of delivering
6Advanced Power SettingsSmartPower settings are configured on a set of DIP switches located inside the lamphead. By placing these switches inside the fi
7High Voltage setting (HV)The Maverick fi xture is designed for use with a 24VDC AC adapter when used on house power. The HV switch allows the fi xtur
8DMX Module OperationWhen the DMX module is connected to the Maverick fixture, control of the fixture is automatically switched to the module. The DMX m
92. Remove the RP panel by sliding it up and out of the fi xture. If the lamp is on, the output will be cut when the panel is removed. 3. Insert a ne
Comments to this Manuals